Lenze MSEMA 080-32 Series - Page 59

Torque plate mounng
You need:
•
Box spanner for xing screws
•
Screw locking adhesive (recommended: Locte 243)
Perform the following acvies:
1.
Clean connecng surface of gearbox and torque plate.
2.
Apply a thin layer of securing adhesive to the thread of the xing screws.
3.
Stop the torque plate in the required angle.
4.
Tighten xing screws with the given torque.
Thread / property class Tightening torque [Nm]
M6 / 8.8 11
M8 / 8.8 25
Mechanical installaon
Mounng
Product extensions
59