9
LB -400Bass DIY Kit
3
Assembling
© 2020 -All rights reserved! Copying is strictly prohibited!
Cut the A4 paper as much as smaller that can
contain the 3 marked positions, use it as a
template for drill 3 holes to a hard carton paper
by screw driver or drills or sharp wooden stick.
Notice: Please remember the top and rear side of
the paper carton same as the body.
Put the pertetiometer into the hole from rear side
to the top side. And cut the paper carton as much
small as you can contain all the potentiometers on
it.
Insert the ground cable wire to the surface of the
body via the access to the ground wire hole. It
have to full contact with the bridge or welding
with the bridge.
Welding the wires as the the circle diagram in
next page.
To Next Page
Loading...