8
3
Assembling
© 2020 -All rights reserved! Copying is strictly prohibited!
Press the pickup fully down into the cavity and let it
stay in the middle and moveable inside of the cavity,
let all the pickups contact with the body completely.
Then pre-drill a small hole. Pre-drill always much
helpful to drive the screw on the wood easier.
Find the pickup screws with springs, install it on the
pickup as the illustration. It means the screw have to
go through the pickup first and spring second.
Drive the screw must down to the hole which you
have pre-drilled, only in the case can make sure the
screw are certainly going down streight but no even
little incline. Drive the screws not to the end and
leave a space adjust the height for both pickups. You
can use your thumb for check the spring working
well.
LB -400Bass DIY Kit
3.3.3 Wiring
Use a pencil for put a A4 paper on the 3 holes for
the control knobs and mark the position for both
Volume and the Tone.
To Next Page
Loading...