LEO JAYMZ LB-400 - Install Bridge and Strings

To Next Page

To Previous Page

Assembling

LB -400Bass DIY Kit

3.3.5 Fix the electronics

3.3.6 Joint the neck

After welding the potentiometers and then insert

the potentiometer to the control knob hole of the

body from the back cavity. Then tighten the nut

with the washers on the top side of the body.

Press the neck into the socket of the body very

tightly, Leo Jaymz electric guitar or bass kits are all

drilled and cutted by CNC machine with accurate

draft, so there is no any gaps between the body and

neck at all when you fully put the neck into the neck

pocket.

Bolt the metal board on the back of body's socket,

align the 4 holes for both the metal board and the

body, drive the biggest screw in our package to the

body for only small section for leave it stand there.

Now clamp it with anything as a buffer for avoid

any scratch on the bass. Here we choose several

pieces of thicker plastic table cover for clamp with

it.

Drill the biggest screws into the body to the 4 holes

of the metal board. Drive the screws very streight to

the body, you'd better choose a powerful cordless

driver for drive it.