6
3
Assembling
© 2020 -All rights reserved! Copying is strictly prohibited!
LB -400Bass DIY Kit
3.3 Installation
Installl the tuning machines for the headstock. Let
the machine heads go through the hold of
headstock form rear side and mounting the nut on
it with washer. But do not tight them very much.
(We make the example in black hardwares, infact
all are same method.)
Use a streight ruler line up to the machine headsfor
align all of them and make each tuning machine
perpendicular to the edge of the headstock, then
tighten the nut with washer in the front side.
Tape drill and leave and the tail section only half
length of the thickness of the headstock. In order
to not drill break through the wood of headstock.
Pre-drill small hole from the rear side of the
headstock to through the screw hole of the
machine heads. Now it's time for tighten the nut
of the machine heads by span.
3.3.1 Mounting the machine heads
To Next Page
Loading...