10 • USER MANUAL LEONE ARROW E-SCOOTER
1. WARNING! DO NOT CHARGE OR STORE THE E-SCOOTER CLOSER THAN 6 METER FROM ANY
FLAME (E.G. FURNACE, FIREPLACE, WATER HEATER, SPACE HEATER)
2. Be sure to only use 230V AC charger for Europe.
3. PLUG the POWER INPUT CORD into the E-Scooter charging receptacle located below the front
of the seat.
4. Plug the 60V battery charger into a 230V AC power source.
5. WARNING! DO NOT KEEP THE E-SCOOTER CONNECTED TO THE CHARGER
FOR LONGER THAN 18 HOURS UNDER ANY CIRCUMSTANCES! DOING SO COULD CAUSE THE BAT-
TERY OR CHARGER TO OVERHEAT AND CAUSE A FIRE.
6. When the light on the charger is red, the E-Scooter battery is being properly charged. When the
E-Scooter battery is fully charged, the light will turn green. If this does not occur after 18 hours of
charging, unplug the charger and call your local dealer.
7. Disconnect the charger from the 230V Power Source.
8. Disconnect the Input Cord from the Charging Receptacle.
9. WARNING! NEVER LEAVE THE BATTERY CHARGER CONNECTED TO THE 230V POWER SOURCE
OR THE E-SCOOTER WHEN NOT CHARGING THE BATTERY.
KEEPING THE CHARGER PLUGGED INTO THE 230V POWER SOURCE AND NOT THE BATTERY
COULD CAUSE THE CHARGER TO OVERHEAT AND OR CAUSE A FIRE.
10. When storing your E-Scooter for lengthy periods of time, the battery should be charged at
least once a month to avoid full depletion.
WARNING!
FAILURE TO KEEP THE E-SCOOTER BATTERY CHARGED WILL CAUSE TOTAL BATTERY FAILURE. DO
NOT ALLOW THE BATTERY TO BECOME FULLY DISCHARGED!!! ALWAYS RECHARGE THE BATTERY
BEFORE THE POWER INDICATOR ON THE INSTRUMENT PANEL SHOWS NO POWER. ALLOWING
THE BATTERY TO FULLY DISCHARGE WILL REDUCE BATTERY LIFE AND MAY RUIN THE BATTERY OR
COULD CAUSE THE BATTERY OR CHARGER TO OVERHEAT AND CAUSE A FIRE THE NEXT TIME THE
E-SCOOTER IS CHARGED.
To Next Page
Loading...