29
HOW DO I INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE STRIKING
DISTANCE FOR EACH CLUB WAS MEASURED? (GX-4 WITH SMART KEY
INSTALLED ONLY)
The procedure for inputting the temperature and alti-
tude at which each striking distance was measured begins
immediately after choosing between yards or meters as
the desired measurement output. Follow each of the
steps above under “How do I input the striking distance
of the 8, 6 and 4-iron?” Once the striking distances have
been input, press MODE and follow
the steps below:
1) The last saved temperature will be flashing in the bottom portion of
the display. If you wish to input a temperature other than the one
shown, proceed to step 2. To save the shown temperature, press MODE
and skip to step 3 below.
2) Press POWER to begin incrementing through the temperature settings.
The default setting is 75 degrees F. Pressing POWER will increment
through a range of 30 degrees to 120 degrees F in 5 degree increments.
To Next Page
Loading...
