18
YARDS/METERS MODE
NOTE: “SET UP” will briefly flash before transition to YARDS/
METERS.
This mode allows you to toggle between Yards or Meters for
the measurement output unit. When set to Yards mode, all
temperature settings will be in Farenheit. When set to Meters
mode, all temperature settings will be in Celsius.
TO CHANGE FROM YARDS TO METERS:
1) Press POWER to activate the rangefinder.
2) Press and hold MODE for at least 2
seconds to enter the Quick Set Menu.
3) Press and release MODE until “Set Up”
flashes briefly in the display, followed by
the word “Unit” shown in the lower display.
4) While the word “Unit” is shown in the
lower display, press and release POWER
as necessary to toggle between “YD” for
Yards, and “M” for Meters, which will be
shown in the lower right portion of
the display.
To Next Page
Loading...
Need help?
General
