What to do if Sensor, EDM and start are simultaneously flashing on Leuze MSI-TR1B Relays?
If the Sensor, EDM, and start indicators are simultaneously flashing, this indicates an internal device error. If restarting the device does not resolve the issue, further assistance is needed.
Why is the EDM flashing on my Leuze Relays?
If the EDM is flashing, this indicates a fault in the EDM wiring. To resolve this, check the wiring of the connected contactors.
How to fix sensor flashing on Leuze Relays?
If the sensor is flashing, it typically indicates a fault in the wiring of the protective sensors. Check the wiring of the protective sensors to resolve this issue.
Details the proper and improper uses of the safety relay to prevent dangers.
Outlines the qualifications and prerequisites for individuals working with the safety relay.
Defines the safety responsibilities of the manufacturer and the operating company.
Explains the function and operation of the start/restart interlock feature.
Describes the function of monitoring external contactor feedback circuits.
Details how to position protective devices to ensure adequate safety distance.
Guides users on how to diagnose and handle failures using LED indicators.
Explains the meaning of LED states, causes, and measures for troubleshooting.
General| Number of signaling outputs (NC) | 1 |
|---|---|
| Category | 4 |
| PL | e |
| SILCL | 3 |
| Protection class | IP20 |
| Response time | 20 ms |
| Switching voltage | 250 VAC |
| Mechanical life | 10, 000, 000 switching cycles |
| Electrical life | 100, 000 cycles |
| Connection type | Screw terminals |
| Housing material | Plastic |
To Next Page
