7
When the Ready LED stops blinking, and remains on,
boot up is complete. If the Status (Orange) LED stays on,
or if the NAS Server repeatedly beeps, there is a hard-
ware problem. Consult the Troubleshooting section of the
User Guide for possible solutions.
Shutdown
To shutdown the NAS Server, press the power switch to start
the shutdown sequence. Wait for all LEDs to turn off.
Removing a USB device
1. Press the USB eject button (for USB 1 or 2) on
the rear panel.
2. Wait for the "USB" LED turn off.
3. Remove the USB device.
You can also use the Windows utility installed from the CD-
ROM:
1. Select "Safely Remove USB Device"
2. Select the desired NAS and USB device, and click the
"Eject" button.
To Next Page
Loading...
