LevelOne POI-2001 User Manual

POI-2001 & POS-1001
Gigabit PoE Injector & Splitter
POI-2002 & POS-1002
PoE Injector & Splitter
POI-3004
Gigabit PoE Injector
POI-3000 & POS-3000
Gigabit PoE Plus Injector & Splitter
POI-3002 & POS-3000
PoE Plus Injector & Splitter
Quick Installation Guide
English
Deutsch
Français
Español
Nederlands
Dansk
Italiano
Ελληνικά
Português
Svenska
Slovenščina
繁體中文
한국어
Русский
Polish

LevelOne POI-2001 Specifications

General

Brand	LevelOne
Model	POI-2001
Category	Media Converter
Language	English

Summary

Installation Steps

Step 1: Connect Power

Connect the AC power cord to the PoE injector and verify the Power LED indicator.

Step 2: Connect to Non-PoE Switch

Connect the injector's Data/In port to a non-PoE switch and set the correct voltage.

Step 3: Connect Splitter to Injector

Connect the Splitter's Power+Data port to the Injector's P+D/Out port via Ethernet cable.

Step 4: Connect Splitter to Network Device

Connect the Splitter's Power OUT and Data OUT cables to the network device's power jack and RJ45 port.

Step 5: Verify Device Operation

Check if the network device is powered on and all cable connections are correct.