Appendix E - Command Line Interface
18
Network Settings
Static IP Address
The static IP address assigned to DSA-1000.
Static Subnet Mask
The subnet mask of DSA-1000.
Static Default Gateway
The default gateway of DSA-1000.
Static DNS Server
Set the DNS server used by DSA-1000.
Transmit Timer
TCP transmit timer, set the desired value or use default
value. When the timer expires for a sent packet, sender will
retransmit the packet.
Server Listening Port
Set the port number for communication with the Gate-
way/Controller.
Lock Password
This attribute is the integer between 0 ~ 9 that will be set as
the password for unlocking the main panel.
Utilities
Firmware Upgrade
Firmware of DSA-1000 can be upgraded by clicking the
Apply button. Note: Upgrade preparations are required
before upgrade, please refer to Appendix B. Firmware
Upgrade
Restart
Click Apply to restart DSA-1000 device.
Reset to Factory Default
Click Apply to reset DSA-1000 to factory default settings.
Status
Software Version
The current software version running on DSA-1000.
To Next Page
Loading...