3 INSTALLATION INSTRUCTIONS
7
3.2.3 Remove fiber dust caps and clean connector end faces with a fiber optic
microfiber dry cleaner.
3.2.4 Connect the appropriate M8 pigtail to the copper conductors on the
OCA. Surge Suppression is strongly recommended, see page 12.
3.2.5 Connect the pre-terminated LC duplex connectors, or MTP
®
connector,
and the M8 connector to the Remote. Ensure the cable loops easily
around the box and that there are no tight bends in the fibers (minimum
bend radius is about 10 cm).
3.2.6 Connect the remote powered device to the remote with a RJ45
terminated patch cord. Use a cable grip if required. Up to 100M of
appropriate category cable may be extended from the Remotes
RJ45 port.
OneReach Cable Assembly
4-Port PoE+ Remote 4-Port PoE Remote
2-Port Remote 1-Port Remote
RJ45 (2)
M8 Power
Connection (4 wire)
M8 Power
Connection (2 wire)
MTP
®
Connection
LC Duplex (4)
RJ45
RJ45 (4)
RJ45 (4)
To Next Page
Loading...
