USB Charger/Tamper Resistant Outlet
Cat. No. T5631
(
15A
)
Rated: USB - 3.6A, Tamper Resistant Outlet - 15A-125V
DI-RXX-T5631-22A
© 2014 Leviton Mfg. Co., Inc.
WARNINGS AND CAUTIONS:
•
TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT
BREAKER OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING!
• To be installed and/or used in accordance with appropriate electrical codes and
regulations.
• If you are not sure about any part of these instructions, consult an electrician.
• This device CANNOT be used for separate feed applications. If the outlet you are
replacing has the top and bottom outlets controlled by separate circuit breakers, you
cannot use this device.
WARNINGS AND CAUTIONS:
• To be used with Class 2 connectors with interconnecting cables.
• The Class 2 USB ports are not intended for use with appliances and
supporting products.
• All connected Class 2 output cables must be routed away from the
receptacle slots or any plug/cord inserted into the receptacle.
• Use this device with copper or copper clad wire only.
For Technical Assistance Call: 1-800-824-3005 (U.S.A. Only) www.leviton.com
• The USB Charger/Tamper Resistant Outlet provides:
- Two 5VDC powered USB ports with a combined total of 3.6A charging
current; and
- A 15A-125VAC outlet.
• The USB ports are used to charge portable electronic devices only
(NO data transfer capability).
FEATURES
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation of the device.
FCC COMPLIANCE STATEMENT
1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER
AT CIRCUIT BREAKER OR FUSE AND TEST THAT THE POWER IS OFF
BEFORE WIRING!
2. This device is to be installed in a wall box measuring at least
3" x 2" x 2-1/2" (standard single gang electrical wall box) and wired
in accordance with NEC article 314 box fill requirements.
3. Remove insulation from each circuit conductor per strip gage on device
[approx. 3/4" (1.9 cm)].
4. Connect wires per WIRING DIAGRAM as follows:
5a. To Side Wire (if more than one wire is required on a terminal, you
cannot side wire and must use the backwire option): Loop wires
clockwise 3/4 turn around the terminal screws. BLACK (hot) wire to BRASS
screw, WHITE (neutral) wire to SILVER screw, GREEN or BARE (ground)
wire to GREEN screw. Firmly tighten screws over wire loop. Terminal screws
accept #14 - #12 AWG copper or copper clad wire.
5b. To Back Wire: Insert straight wires under clamps next to appropriate
terminal screws. BLACK (hot) wire to BRASS screw, WHITE (neutral) wire
to SILVER screw, GREEN or BARE (ground) wire to GREEN screw. Tighten
screws FIRMLY. Backwire clamps accept #14 - #12 AWG copper or copper
clad wire.
6. Mount device in wall box with screws provided and mount wallplate.
7. Restore power at circuit breaker or fuse. Installation is complete.
INSTALLATION
Neutral (White)
Neutre (Blanc)
Neutro (Blanco)
Hot (Black)
Actif (Noir)
Fase (Negro)
Green
Ground
Terre vert
Verde a tierra
Wiring Diagram
Schéma de cablâge
Diagrama de Alambrado
Strip Gage
Gabarit de dénudage
Medida de pelado
3/4"
(1.9 cm)
LIMITED 5 YEAR WARRANTY AND EXCLUSIONS
Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and
proper use for five years from the purchase date. Leviton’s only obligation is to correct such defects by repair or replacement, at its option, if within such five year period the product is returned prepaid, with
proof of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att: Quality Assurance Department, 201 North Service Road, Melville, N.Y. 11747. This warranty excludes
and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused, opened,
abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including
merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for
a particular purpose, is limited to five years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment,
lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.
iPad, Galaxy Tab, Blackberry, iPhone, Nook, Kindle, iPod, Bluetooth are trademarks of their respective owners.
This product is covered by U.S. Patent Nos. 7,355,117; 7,820,909; 8,242,362 and corresponding foreign patents.
For Canada Only
For warranty information and/or product returns, residents of Canada should contact Leviton in writing at Leviton Manufacturing of Canada Ltd to
the attention of the Quality Assurance Department, 165 Hymus Blvd, Pointe-Claire (Quebec), Canada H9R 1E9 or by telephone at 1 800 405-5320.
IMPORTANT NOTE ABOUT THIS USB CHARGER/TAMPER RESISTANT OUTLET:
The 3.6 Amp USB outlets on this USB Charger/Tamper Resistant Outlet are
optimized for use with certain types of devices such as iPad
®
. As a result, the USB
outlets may not charge all models of all brands of your mobile devices. If any of your
devices will not charge using the USB outlets, use a 15A-125V outlet and the AC
adapter of your device for charging.
The two USB outlets are designed to charge two devices simultaneously. However,
if you plug in two devices to charge simultaneously and their combined power
requirements exceed the power capacity of the USB outlets, they will shut down to
protect your devices. In that case, try charging each device by itself.
USB Charger
Chargeur USB
Cargador USB
Tamper Resistant
Outlet
Prise inviolable
Contacto con
Seguro
USB Charger/Tamper Resistant Outlet
Chargeur USB/Prise inviolable
Cargador USB/Contacto con Seguro
Compatible con productos
alimentados por USB, tales como:
Tabletas, iPad
®
, Galaxy Tab
MR
,
Lectores Electrónicos, Nook
®
,
Kindle
®
, Teléfonos Inteligentes,
iPhone
®
, Blackberry
®
,
Reproductores de MP
3
, iPod
®
,
Cámaras Digitales, Auriculares
Bluetooth
®
y más.
Charges most USB powered devices
Pour la plupart des appareils USB
Carga la mayoría de productos
alimentados por USB
Use with Decora
®
wallplate
Utiliser avec plaque murale Decora
MD
Use con la placa de pared Decora
®
Compatible with USB powered
devices such as: Tablets,
iPad
®
, Galaxy Tab
TM
, E-Readers,
Nook
®
, Kindle
®
, Smartphones,
iPhone
®
, Blackberry
®
, MP
3
Players, iPod
®
, Digital Cameras,
Bluetooth
®
Headsets and more.
Compatibilité avec des
appareils pouvant être
réalimentés par un cordon USB
(tablettes comme la iPad
MD
et la Galaxy Tab
MC
; tablettes
de lecture comme la Nook
MD
et la Kindle
MD
, téléphones
intelligents comme le
iPhone
MD
et le Blackberry
MD
,
lecteurs MP3 comme le iPod
MD
,
caméras numériques, casques
Bluetooth
MD
et plus encore).
To Next Page
Need help?
General
