To Next PageTo Next PageWhat to do if there's debris caught around my Lewmar Lifting Systems anchor?
If you find debris caught around your Lewmar Lifting Systems anchor: first, disconnect the 12 Volt power source. Then, remove all the debris. Finally, reconnect the power source.
How to lubricate dry pivot bushings on Lewmar Axis 2022108804 Lifting Systems?
To address dry pivot bushings on your Lewmar Lifting Systems, lubricate all pivot bushings with spray Lithium grease.
What to do if my Lewmar Axis 2022108804 anchor does not extend or lower?
If your Lewmar Lifting Systems anchor isn't extending or lowering, there could be several reasons: * A bad electrical connection: Ensure the Deutsch plug from the RF Module is fully engaged and secured at the anchor’s plug. * No power: Ensure the Deutsch plug from the RF Module is fully engaged and secured at the anchor’s plug. * Loose electrical connections: Check for loose connections at the power source, heat shrink, and switch connections. Tighten or repair as needed. * Disconnected or cut wires: Check for and reconnect or repair/replace any disconnected or cut wires. * Incorrectly installed power connections: Verify the power and ground connections to the vessel’s power source are correctly installed and secure. * Low voltage: Check the vessel’s power source voltage level...
Welcome message and a brief overview of the Lewmar Axis Shallow Water Anchor system.
Critical safety precautions and warnings for operating and installing the anchor system.
Guidance on selecting the optimal location for transom mounting the anchor.
Detailed instructions for physically securing the anchor to the vessel's transom.
Information on alternative mounting solutions beyond the standard transom mount.
Steps for installing the Radio Frequency (RF) module for wireless control.
Instructions for configuring the RF module for momentary or latching operation.
Procedures for deploying the anchor using momentary or latching modes.
Instructions for retrieving the anchor using momentary or latching modes.
Common issues and solutions when the anchor fails to deploy.
Troubleshooting electrical connections, power sources, and wiring problems.
Procedures for rinsing moving parts and lubricating bushings after use.
Guidelines for inspecting electrical connections and fastener tightness periodically.
Advice on maintaining battery power and powering down the RF module during storage.
Steps to disconnect the anchor from its power source and locate the actuator linkage.
Instructions for manually retracting the anchor and securing it for travel.
Details the warranty period for the anchor spike and powder coat finish.
Outlines warranty coverage for linkage arms, hardware, and the remote RF module.
Welcome message and a brief overview of the Lewmar Axis Shallow Water Anchor system.
Critical safety precautions and warnings for operating and installing the anchor system.
Guidance on selecting the optimal location for transom mounting the anchor.
Detailed instructions for physically securing the anchor to the vessel's transom.
Information on alternative mounting solutions beyond the standard transom mount.
Steps for installing the Radio Frequency (RF) module for wireless control.
Instructions for configuring the RF module for momentary or latching operation.
Procedures for deploying the anchor using momentary or latching modes.
Instructions for retrieving the anchor using momentary or latching modes.
Common issues and solutions when the anchor fails to deploy.
Troubleshooting electrical connections, power sources, and wiring problems.
Procedures for rinsing moving parts and lubricating bushings after use.
Guidelines for inspecting electrical connections and fastener tightness periodically.
Advice on maintaining battery power and powering down the RF module during storage.
Steps to disconnect the anchor from its power source and locate the actuator linkage.
Instructions for manually retracting the anchor and securing it for travel.
Details the warranty period for the anchor spike and powder coat finish.
Outlines warranty coverage for linkage arms, hardware, and the remote RF module.
The Lewmar Axis™ Shallow Water Anchor is a marine device designed for anchoring vessels in shallow water. It is available in white (Part # 2022108804) and black (Part # 2022108805) for aftermarket applications. The system allows for quick and secure anchoring by deploying a spike into the waterway's bed.
The Lewmar Axis™ Shallow Water Anchor provides a convenient and efficient way to anchor a boat in shallow water. It operates by extending a spike from the transom of the vessel into the seafloor, securing the boat in place. The anchor can be controlled remotely via a remote control or directly from a hard-mounted switch on the RF module. The system offers both momentary and latching functionality for deployment and retraction. In momentary mode, the anchor extends or retracts as long as the switch is depressed. In latching mode, a single press and release of the button initiates deployment or retraction, and the system automatically stops when sufficient contact with the seafloor is made or when fully retracted. The anchor is designed to sense when it reaches the seafloor or full extraction, momentarily cutting power to the motor to prevent damage. A 5-second delay may occur before the system responds to another input in latching mode.
General| Brand | Lewmar |
|---|---|
| Model | Axis 2022108804 |
| Category | Lifting Systems |
| Language | English |
