LEX Lighting LexIcon User Manual

Lex Lighting Safety Instructions
1. Please keep this User Manual for future reference and be sure to pass this manual on to
anyone using the xture.
2. Always make sure that you are connecting to the proper voltage as stated on the decal or rear
panel of the xture.
3. This product is intended for indoor use only! To prevent risk of re or shock, do not expose
xture to rain or moisture.
4. Make sure there are no ammable materials close to the unit while operating.
5. The unit must be installed in a location with adequate ventilation, atleast 20inches (50 cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
6. Always disconnect from power source before servicing or replacing fuse and be sure to
replace with same fuse rating.
7. Secure xture to fastening device using a safety chain.
8. Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate xture at temperatures
higher than this.
9. In the event of a serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction and will void your warranty. Please contact the nearest authorized technical
assistance center.
10. Never connect the device to a dimmer pack.
11. Make sure the power cord is never crimped or damaged.
12. Never disconnect the power cord by pulling or tugging on the cord.
13. Never carry the xture directly from the cord. Always use the hanging/mounting bracket.
14. Avoid direct eye exposure to the light source while it is on.

LEX Lighting LexIcon Specifications

General

Brand	LEX Lighting
Model	LexIcon
Category	Lighting Equipment
Language	English

Summary

Lex Lighting Safety Instructions

General Safety Instructions

A comprehensive list of 14 safety instructions covering proper usage, installation, maintenance, and electrical precautions.

Menu Configuration and Modes

Sound to Light / Sound Active Mode

Instructions on how to activate and use the sound-reactive mode using the built-in microphone.

Auto Run Mode & Pattern Selection & Speed

Guide to selecting pre-programmed patterns and adjusting playback speed in automatic mode.

Static Mode / Color Select & Strobe Modes

Steps to choose static colors or combinations and apply flash or strobe effects.

Blackout Mode

Enables turning off all light output, regardless of the current operating mode.

Display Settings

Option to invert the digital display orientation, with a note on button function changes.

DMX Mode, Channels, Addressing

Configuration for operating the fixture using DMX, selecting between 2 or 8 channels.

DMX Mode Setup

Guidance for setting up the fixture for use with a universal DMX controller.

Master/Slave Mode

Instructions for setting up one unit as a master to control multiple slave units via DMX.