Lex Lightning Dualex II User Manual

Lex Lighting Safety Instructions
1. Please keep this User Manual for future reference and be sure to pass this manual on to
anyone using the xture.
2. Always make sure that you are connecting to the proper voltage as stated on the decal or rear
panel of the xture.
3. This product is intended for indoor use only! To prevent risk of re or shock, do not expose
xture to rain or moisture.
4. Make sure there are no ammable materials close to the unit while operating.
5. The unit must be installed in a location with adequate ventilation, atleast 20inches (50 cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
6. Always disconnect from power source before servicing or replacing fuse and be sure to
replace with same fuse rating.
7. Secure xture to fastening device using a safety chain.
8. Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate xture at temperatures
higher than this.
9. In the event of a serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction and will void your warranty. Please contact the nearest authorized technical
assistance center.
10. Never connect the device to a dimmer pack.
11. Make sure the power cord is never crimped or damaged.
12. Never disconnect the power cord by pulling or tugging on the cord.
13. Never carry the xture directly from the cord. Always use the hanging/mounting bracket.
14. Avoid direct eye exposure to the light source while it is on.

Lex Lightning Dualex II Specifications

General

Light Source	LED
Light Source Type	LED
Beam Angle	120°
Color Temperature	5000K
IP Rating	IP65

Summary

Lex Lighting Safety Instructions

General Safety Precautions

Provides essential safety guidelines for operating and maintaining the lighting fixture, including handling, environment, and electrical safety.

Operating Modes

Sound to Light Mode

Configures the unit to react to ambient sound, cycling through programmed chases.

Auto Mode

Sets the unit to automatically cycle through programmed chases without sound input.

Master/Slave Mode

Enables synchronized operation of multiple Dualex II units via linked cables.

DMX Mode

Setting DMX Mode

Instructions for setting the Dualex II to DMX mode and assigning its address for controller communication.

Fixture Mounting and Maintenance

Mounting Instructions

Provides guidance on securely mounting the lighting fixture to various surfaces like ceilings or trusses.

Care and Maintenance

Guidance on cleaning the fixture to maintain its finish and performance, plus instructions for safe fuse replacement.