MPX G2 SERVICE BULLETIN
Please contact LEXICON CUSTOMER SERVICE with any questions.
Sbmpxg2_980903-00
Date: October 19, 1998
2
INSTRUCTIONS:
1. Verify that the power switch is turned off and the power cable is disconnected
from the unit.
2. Remove the top cover:
2.1. Remove the two-(2) rack mounting brackets by removing the two-(2) screws
holding each bracket to the side of the cover behind the front panel.
2.2. Remove the remaining four-(4) screws affixing the cover to the chassis (2-
rear, 2-side).
3. Remove the top cover.
4. Apply a small amount of RTV silicone adhesive at the cable connections J2 (Input
board) and J21 (main board).
5. Reinstall the top cover and rack mounting brackets.
To Previous Page
Loading...
