26
MAchINe MeNU
The Machine menu lets you adjust settings for a single virtual machine. To
access the Machine menu, press the Select knob while a Machine Preset is
loaded.
The sub-menus vary depending on what algorithm is active.
SoFt RoW SetUP
This sub-menu lets you assign parameters to a Machine Preset’s soft row. The
soft row is the list of parameters that appears below a Machine Preset’s name
in the Preset screen. You can easily adjust these parameters with the A, B,
and C knobs (press Knob A to see more parameters in the soft row).
I/o SettINGS
Here you can adjust the following settings (depending on the selected pre-
set):
Wet Dry Mix
Adjusts the proportion of wet (processed) signal to dry (unprocessed) signal.
Ranges from 0% (all dry) to 100% (all wet). In almost all cases you will
leave this at 100%, and control levels on your mixer.
Input Level
Controls the amount of signal admitted into the process from the input.
Ranges from 0.0dB INV to –90.0dB INV or OFF INV, and from –90.0dB
or OFF to 0.0dB.
Output Level
Controls the amount of post-mix signal emitted onto the output. Ranges
from –90.0dB or OFF to 0.0dB.
vARIoUS PARAMeteRS
The sub-menus that appear below the I/O Settings sub-menu depend on the
active algorithm. Refer to the Parameters section on page 39 for more infor-
mation.
To Next Page
Loading...
