Signature 284 User Guide
5
Getting the Tone You Want
The sonic signatures of many different guitar sounds are based on
power amp behavior as much as preamp gain and tone settings.
For modern high gain tones, use Gain Boost (pull out the Gain knob) to
get lots of preamp distortion, but keep the power amps clean by setting
the knob no higher than 4 or so. This will deliver a smooth, tight
distortion with lots of definition.
Front Panel Controls
For vintage blues tones, keep the Gain in Normal mode (pushed in), but
crank it up to 7 or so to push the power amps harder. You’ll notice that
the amount of “sag” (power amp compression) increases as you turn
the Volume controls beyond 5. When set up this way, the Signature 284
is most responsive to nuances of touch and style — the tone is totally
authentic, the voice is yours alone.
For tones that emphasize the Class “A” characteristics of the power
amps, keep the Gain in Normal mode (pushed in) and set it below 5.
Dial in some power amp distortion by setting the Volume controls
above 5. Pushing the power amps this way creates a throaty quality —
you’ll also notice that the tone controls are very responsive when the
amp is used this way.
To Next Page
Loading...
