x
Power On/Off
#Hearthedifference GTX USER MANUAL
Power On: Press and hold the Power Button for 1 second.
The EDwill blink blue. Voice prompt "Power On "and the current battery life.
Power Off: Press and hold the Power Button for 1 second.
The EDwill blink red.Voice prompt "Power Off."
Battery Charging:
Plugthe USB-Ccable into the LISB-Cport to charge by any DC5V power supply, such
as mobile phone charger, computer, laptop or power bank, Etc.The LEDturns red
while charging and then turns blue when the main unit is fully charged. t takes about
2.5 hours to charge entirely.
Battery Life Prompt: While in standby mode, double-click the up Button, the GTX
will prompt the current battery life.
It will prompt one Of five levels:
100%, 80%, 50%, 30%, LOW.
Note: Whilethe battery capacity is below 30%,the device will notify you every 20
minutes until the device powers off. It indicates that around 1-1.5h of use remains.
Pairing GTX with Bluetooth Devices
Note: A single GTXcan connect with two mobile phones and one other Bluetooth
device at once. It can automatically connect to your last paired device as long as
Bluetooth is enabled or in standby mode without being connected with any devices.
Pairing Phone
Step 1:With the unit powered off, press and hold the Power Button for 5 seconds until
the led flashes red and blue , to enter pairing mode.
Step 2: Go to Bluetooth settings on your phone, Select "GTX".
Some mobile phones may need a PIN.Enter "0000" for the PINif required.
Step 3: Pleaseconfirm in your phone if the pairing is complete.
Note: The LEDwill blink blue and voice prompt pairing successfully, indicating the
connection is complete.
Pairing Bluetooth GPS Navigation
Step 1:While powered Off,press and hold the Power Button for about 5s until the LED
light flashes blue and red alternately , the device will prompt " pairing' to enter pairing
mode. Whenthe pairing is completed, the indicator light will blink blue, and the voice
09
To Next Page
Loading...
