testing magnet
Connection-wire diagram
BASE
RELAY
+
RELAY
5
6
2
3
4
_
① Terminal 5 connect" +"
② Terminal 2 connect "–"
③ Terminal 6 and 3(4)─relay output terminal.
Installation
1.Shut off power;
2.Press and hold the base and turn it counterclockwise, take down base;
3.According to the number mark on base and connection-wire diagram, connect wire to number corresponding screw with
gasket;
4.Fix the base on the selected position;
5.Cover the alarm body: make the short line on the base aim at the long line on alarm body and turn clockwise until the
long line on base aim at the long line on alarm body.
Test
1.Switch on power, the indicators should flash once every about 7sec.
2.Use magnet to attract inner pole reed pipe on the opposite position of
indicator,the indicators should always light.
3.If the indicators don’t always light, please check if the magnet using is correct.
4.Simulating smoke test: blow smoke into detector, the indicators flash quickly and
then always light.
Regular maintenance
1. Test it at least once a week.
2. Clean the smoke alarm at least once a month. Gently vacuum off dust using vacuum’s soft brush attachment.
3. Never use water, cleansers to clean your smoke alarm since they may damage the unit.
Limitation of smoke alarm
1. It can only tell us that fire will occur so that you can deal with the fire in time and have more time avoiding great loss.
2. It is not safe absolutely, because it can not detect smoke absolutely, during smoke appear if there is block to obstruct
smoke or smoke is taken off by air current, smoke will not reach the smoke alarm.
3. It is not fire extinguisher and also can not sense fire, so you should have the fire-fighting devices to help.
What to do when fire occur
1. Dial telephone to the fire control office.
2. Don’t feel panic, keep calm. Go through the route way planned in advanced and leave as quickly as possible, don’t
waste much time to take things.
3. Feel whether the door is hot or not. If hot, don’t open the door; if not, you also should prevent the flame in and you can
choose other route way to flee.
4. With wet towel cover your mouth and nose, don’t inbreathe smoke.
5. After fleeing out ,gather in the indicated place and ensure person is not injured or dead.
To Previous Page
Loading...
