1. Remove the developer roller screw and cover. Remove the screw and bend the cover out from the middle.
There are two pins on each side that will break if you just pull it off.
2. Remove the encoder wheel. Pry it off from the backside. 3. Remove the fill plug, and dump out any remaining toner.
LEXMARK E260 • 360 • 460 • X264 • 363 • 364 MFP TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...
