131
1-5. Opening and closing the windows and moon roof
1
Before driving
■ When the power window does not close normally
If the jam protection function is operating abnormally and a window cannot be
closed, perform the following operations using the power window switch on the rel-
evant door.
● RX350: After stopping the vehicle, the window can be closed by holding the
power window switch in the one-touch closing position while the “ENGINE
START STOP” switch is turned to IGNITION ON mode.
● RX450h: After stopping the vehicle, the window can be closed by holding the
power window switch in the one-touch closing position while the “POWER”
switch is turned to ON mode.
● If the window still cannot be closed even by carrying out the operation
explained above, initialize the function by performing the following procedure.
Hold the power window switch in the one-touch closing position. Con-
tinue holding the switch for a further 6 seconds after the window has
closed.
Hold the power window switch in the one-touch opening position. Con-
tinue holding the switch for a further 2 seconds after the window has
opened completely.
Hold the power window switch in the one-touch closing position once
again. Continue holding the switch for a further 2 seconds after the win-
dow has closed.
If you release the switch while the window is moving, start again from the beginning.
If the window continues to close but then re-open slightly even after performing the
above procedure correctly, have the vehicle inspected by your Lexus dealer.
To Next Page
Loading...
