191
2-5. Driving information
2
When driving
■ When connecting and disconnecting a trailer
Connecting
Set the rear height control air suspension to “LO” mode.
Turn off the engine switch or the rear height control air suspension.
Connect the trailer.
Turn on the switch that was turned off on STEP 2.
Set the rear height control air suspension to “N” mode.
Disconnecting
Set the rear height control air suspension to “LO” mode.
Turn off the engine switch or the rear height control air suspension.
Set the supporting leg of the trailer on the ground and raise the hitch by
4 in. (100 mm).
Turn on the switch that was turned off on STEP 2.
Wait until vehicle height is stabilized.
Make sure the hitch is disconnected. If the hitch does not disconnect, raise
the hitch higher and repeat steps 2 through 5.
Move the vehicle forward in the “LO” mode where the hitch does not
touch anything in the “N” mode.
Set the rear height control air suspension in the “N” mode.
STEP 1
STEP 2
STEP 2
STEP 1
STEP 3STEP 3
STEP 1
STEP 1
STEP 5STEP 5STEP 5
STEP 1
STEP 2
STEP 2
STEP 1
STEP 3STEP 3
STEP 1
STEP 1
STEP 5STEP 5STEP 5
STEP 1
STEP 5STEP 6STEP 6STEP 6
STEP 1
STEP 5STEP 6STEP 7STEP 7
STEP 5STEP 6STEP 8STEP 8