B02121
Example:
NEVER USE OHMMETER ON AN AIRBAG OR PRETENSIONER
IN-16
-INTRODUCTION FOR ALL OF VEHICLES
16Author: Date:
2005 LEXUS IS300 (RM1140U)
(h) SEAT BELT PRETENSIONER
(1) Never measure the resistance of the seat belt pre-
tensioner. This may cause the seat belt pretension-
er to activate, which could cause serious injury.
(2) Never disassemble the seat belt pretensioner.
(3) Never install the seat belt pretensioner in another
vehicle.
(4) Store the seat belt pretensioner where the ambient
temperature remains below 80°C (176°F), has low
humidity and is away from electrical noise.
(5) Before using an electric welder, first disconnect the
connector (the connector is yellow and has 2 pins).
(6) As a safety measure, always activate the seat belt
pretensioner before disposal (see page BO-220 ).
Activate the pretensioner in safe place away from
electrical noise.
(7) The seat belt pretensioner becomes hot after ac-
tivation. Allow it to cool before disposing. Never use
water to cool seat belt pretensioner.
To Next Page
Loading...
