a. Remove the 5 bolts and driver side knee airbag.
b. Disconnect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire
harness.
11. REMOVE INSTRUMENT PANEL BOX ASSEMBLY
a. Detach the 5 claws.
b. Remove the box and then disconnect the connectors.
12. REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK
a. Rear Side:
i. Disconnect the 7 connectors.
ii. Detach the 2 clamps.
iii. Remove the 2 bolt and nuts.
b. Front Side:
i. Disconnect the 5 connectors.
c. Remove the ECU with junction block.
To Next Page
Loading...
