i. Place protective tape as shown in the illustration.
ii. Using a moulding remover, detach the 6 claws and remove the side
panel.
b. w/ Airbag Cut Off Switch:
i. Place protective tape as shown in the illustration.
ii. Using a moulding remover, detach the 6 claws.
iii. Remove the side panel and disconnect the connector.
5. REMOVE FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedures described for the LH side.
6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
a. Remove the 2 screws.
b. Detach the 3 claws.
c. Remove the under cover and disconnect the connectors.
7. REMOVE COWL SIDE TRIM BOARD RH
a. Remove the cap nut.
b. Detach the 2 clips and remove the trim board.
8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
a. Using a screwdriver, detach the 2 claws and open the hole cover.
To Next Page
Loading...
