DTC B2610 Tilt Position Sensor or Tilt Motor Circuit Malfunction
for Preparation Click here
DESCRIPTION
The tilt motor is operated by the power source voltage supplied from the multiplex tilt and telescopic ECU and tilts the steering column up and down. The
tilt position sensor (Hall IC) in the tilt motor detects the tilt angle of the steering column and outputs a signal to the CPU based on that tilt.
HINT:
Limit positions can be confirmed on the screen of the intelligent tester.
DTC Code Detection Condition Trouble Area
B2610
The tilt operation stops within the operation range while
operating.
Harness or connector
Tilt position sensor or tilt motor
Multiplex tilt and telescopic ECU
WIRING DIAGRAM
INSPECTION PROCEDURE
1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TILT UP/DOWN)
To Next Page
Loading...
