10. INSTALL FRONT WHEEL RH
Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
11. ADD POWER STEERING FLUID
12. BLEED POWER STEERING FLUID
a. Check the fluid level.
b. Jack up the front of the vehicle and support it with stands.
c. Turn the steering wheel.
i. With the engine stopped, turn the wheel slowly from lock to lock several times.
d. Lower the vehicle.
e. Start the engine.
f. Idle the engine for a few minutes.
g. Turn the steering wheel.
i. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to
the opposite full lock position and keep it there for 2 to 3 seconds.*1
ii. Repeat *1 several times.
NOTICE:
For vehicles with VGRS, if the steering wheel is turned from lock to lock repeatedly, the system may stop operating and the
amount of rotation before the steering wheel locks may increase due to operation of the overheating prevention function. When
the system temperature drops, the system operation automatically returns to normal.
h. Stop the engine.
i. Check for foaming or emulsification.
If the system has to be bled twice because of foaming or emulsification, check
for fluid leaks in the system.
j. Check the fluid level.
13. INSPECT FOR POWER STEERING FLUID LEAK
To Next Page
Loading...
Need help?
General
