11 (GND) (IG) 11 to 14 V
NG Go to step 3
OK
REPLACE MULTIPLEX TILT AND TELESCOPIC ECU ( Click here)
3.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)
a. Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified
Condition
E27-11 (GND) - Body
ground
Always Below 1 Ω
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
4.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - MAIN BODY ECU)
To Next Page
Loading...
