Lexus LX - INSTALL STEERING ACTUATOR ASSEMBLY

STEERING COLUMN ASSEMBLY > INSTALLATION
for Preparation Click here
1. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT
a. Align the part of the dust cover labeled A with the No. 2 steering intermediate
shaft, and install the No. 2 steering intermediate shaft assembly to the steering
link assembly.
b. Install the bolt.
Torque:
35 N*m{ 360 kgf*cm , 26 ft.*lbf }
NOTICE:
Be careful not to damage the dust cover.
2. INSTALL STEERING COLUMN HOLE COVER SUB-ASSEMBLY
a. Install the steering column hole cover with the 4 bolts and nut.
Torque:
5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
HINT:
Install the steering intermediate shaft assembly from the inside of the vehicle.
b. Install the clamp to the steering column hole cover.
3. INSTALL STEERING ACTUATOR ASSEMBLY
a. Make sure that the power steering link assembly is centered.
b. Install the steering actuator assembly.
i. If installing a new steering actuator assembly:
Install the steering actuator assembly with the white line on the upper
surface of the spiral case facing down.
NOTICE:
Do not pull out the center lock pin.
ii. If reinstalling the removed steering actuator assembly: