1. Slowly turn the spiral case clockwise until it locks.
2. Turn the spiral case two turns counterclockwise from the
lock position.
3. Align the slit of the sliding yoke with the alignment mark
(▲).
4. Install the steering actuator assembly with the white line
on the upper surface of the spiral case facing down.
c. Align the matchmarks on the No. 2 steering intermediate shaft and steering
actuator.
HINT:
Install the steering actuator from the inside of the vehicle.
NOTICE:
Do not fold back the boot part of the steering hole cover or turn
it excessively. If it is turned excessively, return it to its original
position.
Do not turn the actuator body and the spiral case.
d. Install the bolt.
Torque:
35 N*m{ 360 kgf*cm , 26 ft.*lbf }
e. Using needle nose pliers, lock the clamp to the steering column hole cover to
install it.
NOTICE:
Be careful when performing the operation as the clamp may not lock if the
claws of the clamp are deformed.
f. Move the lock in the direction of the arrow and connect the steering actuator
connector.
HINT:
When a new actuator is installed, remove the center lock pin.
g. Connect the connector.
To Next Page
Loading...
