Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected ( Click here).
c. Rotate the spiral cable with steering sensor counterclockwise slowly by hand
until it feels firm.
CAUTION:
Do not turn the spiral cable with steering sensor by the airbag wire harness.
d. Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to
align the marks.
CAUTION:
Do not turn the spiral cable with spiral sensor by the airbag wire harness.
HINT:
The spiral cable with steering sensor will rotate approximately 2.5 turns to
both the left and right from the center.
25. INSTALL STEERING WHEEL ASSEMBLY
a. Align the matchmarks on the steering wheel assembly and steering main shaft
assembly.
b. Install the steering wheel assembly set nut.
Torque:
50 N*m{ 510 kgf*cm , 37 ft.*lbf }
26. INSTALL STEERING PAD
a. Support the steering pad with one hand.
b. Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire
harness.
c. Connect the horn connector.
d. Confirm that the circumference groove of the "TORX" screw fits in the screw
case, and place the steering pad onto the steering wheel.
e. Using a T30 "TORX" socket wrench, tighten the 2 screws.
To Next Page
Loading...
