a. Remove the front stabilizer bar from the frame assembly.
11. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT
a. Loosen the bolt and remove the No. 2 intermediate shaft.
HINT:
If the dust cover is removed/installed or replaced, place matchmarks on the
dust cover and steering link.
NOTICE:
It is possible to install the intermediate shaft to the same position it was
removed from without placing matchmarks due to the dust cover part labeled
A. Therefore, do not remove the dust cover from the steering link.
12. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
a. Remove the cotter pin and nut.
b. Using SST, disconnect the tie rod end LH from the steering knuckle.
SST
09610-20012
NOTICE:
Do not damage the front disc brake dust cover.
Do not damage the ball joint dust cover.
Do not damage the steering knuckle.
13. DISCONNECT TIE ROD END SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
14. REMOVE TIE ROD END SUB-ASSEMBLY LH
a. Put matchmarks on the tie rod end LH and steering rack end.
b. Measure length A and record the measurement.
c. Remove the tie rod end.
To Next Page
Loading...
