STEERING LINKAGE > REASSEMBLY
for Preparation Click here
1. INSTALL STEERING RACK END SUB-ASSEMBLY
a. Temporarily install the 2 steering rack ends to the power steering rack.
b. Fill up the ball joint of the steering rack ends with MP grease.
c. Using SST, install the power steering rack end (RH side) to the power steering
rack.
SST
09922-10010
Torque:
without SST:
147 N*m{ 1499 kgf*cm , 108 ft.*lbf }
with SST:
110 N*m{ 1122 kgf*cm , 81 ft.*lbf }
HINT:
Rotate SST in the direction shown in the illustration.
Use a torque wrench with a fulcrum length of 380 mm (15.0 in.).
d. Using SST and a wrench, install the power steering rack end (LH side) to the
power steering rack.
SST
09922-10010
Torque:
without SST:
147 N*m{ 1499 kgf*cm , 108 ft.*lbf }
with SST:
110 N*m{ 1122 kgf*cm , 81 ft.*lbf }
HINT:
Rotate SST in the direction shown in the illustration.
Use a torque wrench with a fulcrum length of 380 mm (15.0 in.).
2. INSTALL NO. 1 STEERING RACK BOOT
a. Apply silicon grease to the inside of the small opening of the boot.
b. Install the 2 boots to the groove on the rack housing.
3. INSTALL STEERING RACK BOOT CLAMP RH
a. Using SST, install a new boot clamp as shown in the illustration.
SST
09521-24010
To Next Page
Loading...
