Lexus LX - Page 547

a. Connect the tie rod end LH to the steering knuckle with the nut.
Torque:
69 N*m{ 704 kgf*cm , 51 ft.*lbf }
b. Install a new cotter pin.
HINT:
If the holes for the cotter pin are not aligned, tighten the nut up to another 60°.
8. CONNECT TIE ROD END SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the RH side.
9. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT
a. Align the part of the dust cover labeled A with the No. 2 steering intermediate
shaft, and install the No. 2 steering intermediate shaft assembly to the steering
link assembly.
b. Install the bolt.
Torque:
35 N*m{ 360 kgf*cm , 26 ft.*lbf }
NOTICE:
Be careful not to damage the dust cover.
10. INSTALL FRONT STABILIZER BAR
a. Set the stabilizer bracket so that the arrow mark is facing the front side of the
vehicle.
b. Temporarily install the 2 stabilizer brackets and front stabilizer bar with the 4
bolts.