b. Install the clamp and connect the pressure feed tube (return tube side) to the
power steering link.
c. Using a union nut wrench, connect the pressure feed tube (pressure feed tube
side) to the power steering link.
Torque:
without union nut wrench:
44 N*m{ 449 kgf*cm , 32 ft.*lbf }
with union nut wrench:
40 N*m{ 409 kgf*cm , 30 ft.*lbf }
HINT:
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
This torque value is effective when union nut wrench is
perpendicular to the torque wrench.
5. INSTALL TIE ROD END SUB-ASSEMBLY LH
a. Align the matchmarks of the tie rod and rack end, and temporarily install the tie
rod with the lock nut.
HINT:
After adjusting toe-in, tighten the lock nut.
Torque:
82 N*m{ 836 kgf*cm , 60 ft.*lbf }
b. Check that length A is the same as the length measured previously.
6. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the RH side.
7. CONNECT TIE ROD END SUB-ASSEMBLY LH
To Next Page
Loading...
