Lexus LX - Page 69

10.CHECK STEERING WHEEL OPERATION
a. Start the engine.
b. Perform the steering angle sensor initialization ( Click here).
c. Turn the steering wheel from lock to lock and check that it rotates approximately 2.7 turns.
d. Drive the vehicle and confirm that the steering wheel is centered.
NEXT
END
VGRS SYSTEM CALIBRATION PROCEDURE (WHEN USING INTELLIGENT TESTER)
1.FACE TIRES STRAIGHT AHEAD
NOTICE:
Drive the vehicle to confirm that the steering wheel is centered.
NEXT
2.PERFORM VGRS SYSTEM CALIBRATION
a. Connect the intelligent tester to the DLC3.
b. Turn the engine switch on (IG).
c. Turn the tester on.
d. Enter the following menus: Chassis / VGRS / Utility / Steering Angle Adjust.
Then, press "Next".
e. Follow the instructions on the tester, and press "Next".
NOTICE:
Press the "Next" key even if DTC C15B4/71 is output.
f. Follow the instructions on the tester, and press "Next".
g. Follow the instructions on the tester, and press "Next".
NOTICE:
Ensure that the engine switch is off.
h. Follow the instructions on the tester, and press "Next".
i. Follow the instructions on the tester, and press "Next".
NOTICE:
If the centering of the spiral cable was not confirmed when the steering wheel was installed, confirm the centering of the spiral cable ( Click
here).
j. Follow the instructions on the tester, and press "Next".
NOTICE:
Do not touch the steering wheel during these procedures.
k. Follow the instructions on the tester, and press "Next".
l. Follow the instructions on the tester, and press "Next".
NOTICE:
Do not touch the steering wheel during these procedures.
m. "NOW CALIBRATING" is displayed and the display switches automatically to the next screen.