NOTICE:
Do not touch the steering wheel during these procedures.
n. "Steering Angle Adjust is complete." is displayed. Then, check that the VGRS system calibration is completed normally.
o. Select "Exit" to return the display to the "MENU" screen.
NEXT
3.CHECK MASTER WARNING LIGHT
a. Confirm that the master warning light is off.
b. Turn the engine switch off.
c. Disconnect the intelligent tester from the DLC3.
d. Turn the engine switch on (IG).
e. Confirm that the master warning light is operating normally.
NEXT
4.CHECK STEERING WHEEL OPERATION
a. Start the engine.
b. Perform the steering angle sensor initialization ( Click here).
c. Turn the steering wheel from lock to lock and check that it rotates approximately 2.7 turns.
d. Drive the vehicle and confirm that the steering wheel is centered.
NEXT
END
To Next Page
Loading...
