Velocity Min.: -2047 deg./s, Max.: 2048.94 deg./s Steering wheel turned to left:
Display value changes in
positive direction
Actuator
Target
Angle 1
Actuator target angle 1/
Min.: -2047 deg., Max.: 2048.94 deg.
Steering wheel turned: -2047
to 2048.94 deg.
-
Actuator
Target
Angle 2
Actuator target angle 2/
Min.: -2047 deg., Max.: 2048.94 deg.
Steering wheel turned: -2047
to 2048.94 deg.
-
Actuator
ReVolution
Spd
Actuator revolution speed/
Min.: -2047 deg./s, Max.: 2048.94 deg./s
Steering wheel turned to
right: Display value changes
in negative direction
Steering wheel turned to left:
Display value changes in
positive direction
-
Actuator
Deviation
Ang
Actuator deviation angle/
Min.: -32 rad., Max.: 32 rad.
VGRS system operating: -32
to 32 rad.
-
Mode State
Mode state/
00, 01, 02, 03, 04, 05, 06, 07, 08, 09, 0A,
0B, 0C, 0D, 0E, 0F or 10
- -
NOTICE:
*1: This data must be "Valid" before proceeding with any steering adjustment. If "Invalid" is displayed, perform the steering angle sensor
initialization procedure. If the steering actuator or steering control ECU has been replaced, perform VGRS system calibration (steering
angle adjustment).
HINT:
*2: If "Rec" is displayed, enter the VGRS menu on the intelligent tester, select record clearance, and follow the prompts to set to "Unrec".
ACTIVE TEST
HINT:
Using the intelligent tester to perform Active Tests allow relays, VSVs, actuators and other items to be operated without removing any parts. This non-
intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing
Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Test.
a. Connect the intelligent tester to the DLC3.
b. Turn the engine switch on (IG).
c. Turn the tester on.
d. Enter the following menus:
Body / Combination meter / Active Test.
e. According to the display on the tester, perform the Active Test.
Combination Meter:
Tester Display Test Part Control Range Diagnostic Note
Master Warning Master warning light OFF/ON Confirm that the vehicle is stopped and the engine is running.
To Next Page
Loading...
