What does it mean when the LEYBOLD GRAPHIX THREE Controller displays 'Analog sensor signal out of range - too high'?
This message indicates that the measurement signal from the sensor is significantly above the permissible range.
What does it mean when the LEYBOLD Controller displays 'Analog sensor signal out of range - too low'?
This message indicates that the measurement signal from the sensor is significantly below the permissible range.
What does it mean when the LEYBOLD GRAPHIX THREE Controller displays 'One filament broken'?
This message indicates a hot cathode error (filament 1 defectively) with IONIVAC sensors of ITR200 series. No answer.
What does it mean when the LEYBOLD GRAPHIX THREE displays 'Both filaments broken'?
This message indicates a hot cathode error (both filaments defectively) with IONIVAC sensors of ITR200 series. No answer.
What does 'Error pirani' mean on my LEYBOLD GRAPHIX THREE Controller?
An 'Error pirani' message on your LEYBOLD Controller indicates a Pirani error with IONIVAC sensors of the ITR90 series. No answer.
What does 'Error ion gauge' mean on my LEYBOLD GRAPHIX THREE Controller?
An 'Error ion gauge' message on your LEYBOLD Controller indicates a hot cathode error (filament defectively) with IONIVAC sensors of the ITR90 series. No answer.
What causes a 'Sensor-ID unknown or not available' error on a LEYBOLD GRAPHIX THREE?
A 'Sensor-ID unknown or not available' error on your LEYBOLD Controller is caused by an identification resistor of sensor identification that is either unknown or missing. No answer.
What does 'Sensor-ID short circuit' mean on my LEYBOLD GRAPHIX THREE Controller?
A 'Sensor-ID short circuit' error on your LEYBOLD Controller indicates an error in the electric circuit of sensor identification. No answer.
Critical safety warnings regarding mains voltage, improper utilization, and connection errors.
Details all rear panel connection ports for power, sensors, and interfaces.
Step-by-step guide for powering the instrument on and off, including boot sequence.
Explains operation via touchscreen, main menu, and channel menu navigation.
Instructions and necessary preparations for updating the instrument's firmware.
Explains error messages on screen and lists sensor and system errors with causes.
General| Category | Controller |
|---|---|
| Manufacturer | LEYBOLD |
| Model | GRAPHIX THREE |
| Display | LCD |
| Input Voltage | 100 - 240 VAC |
| Frequency | 50/60 Hz |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 20% to 80% non-condensing |
| Communication Interface | RS-232 |
| Certifications | CE |
To Next Page
