29
ENGLISH
[Settings] [Picture] [Picture Reset]
• [Do you want to reset your picture settings?]
- [Yes]: Returns to the default settings.
- [No]: Cancel the select.
[General]
[Settings] [General]
• [Language]: Sets the menu screen to the desired language.
• [SMART ENERGY SAVING]: Conserve energy by using luminance compensation algorithm.
- [High]: Saves energy using the high-efficiency [SMART ENERGY SAVING] feature.
- [Low]: Saves energy using the low-efficiency [SMART ENERGY SAVING] feature.
- [Off]: Disables the feature.
NOTE
• The value of energy saving data may differ depending on panel and panel suppliers.
• If you select the option of [SMART ENERGY SAVING] is [High] or [Low], monitor luminance become higher or
lower depend on source.
• [Deep Sleep Mode]: When [Deep Sleep Mode] is [On], power consumption is minimized while the monitor is
in standby mode.
- [On]: Enables [Deep Sleep Mode].
- [Off]: Disables [Deep Sleep Mode].
* If Deep Sleep Mode is Off, monitor only turns off the back light while the monitor is standby mode.
• [Power LED]: When the Power LED function is turned on, it operates as follows:
- On mode: White
- Sleep mode(Standby Mode): White Blinking
- Off mode: Off
• [Automatic Standby]: Feature that automatically turns off the monitor when there is no movement on the
screen for a period of time. You can set a timer for the auto-off function. ([Off], [4H], [6H], and [8H])
• [DisplayPort Version]: Set DisplayPort Version to the same version as the connected external device. ([1.4]
and [1.2]) To use the HDR function, set to [1.4].
• [DP OUT]: Set DP OUT for Multi Stream Transport.
- [On]: Returns to the default settings.
- [Off]: Cancel the select.
NOTE
• Make sure that the graphics card supports the MST function.
• Because of the bandwidth limit of Display Port Ver.1.2, up to 2560 x 1440 @ 75Hz monitor can be connected
and used.
• If the DP OUT is enabled, HDR is not supported.
To Next Page
Loading...
