58
206-4200
COMPONENT
IN
RS-232C IN
(SERVICE ONLY)
UPDATE
RESET
AUDIO IN
(RGB/DVI)
.....
....
RL
P
B
Y P
R
..... .....
2
1
HDMI/DVI IN
OPTICAL
DIGITAL
RJP
INTERFACE
VIDEO
L/MONO-AUDIO-R
AV IN 1
RGB IN (PC)
.....
.....
.....
LAN2
TV-LINK CFG
GAME
CONTROL/MPI
..... .....
AUDIO OUT
SERVICE
ONLY
SPEAKER
OUT
8
LAN1
Reference: LD660H/LD665H Rear Jack Panel
LAN 2
Use for video IP and/or
network connections.
RGB IN (PC)
Connection for RGB
output from PC.
TV-LINK CFG
Use for direct PC-to-TV
FTG configuration.
UPDATE
Restricted to software updates.
RESET
Initiates a hardware reset and
switches the TV to standby.
GAME CONTROL/MPI
When the TV/EBL is in Pass-through Mode, the MPI
function enables an external MPI control device (i.e.,
clone programmer, VOD/PPV STB, etc.) to control the
TV. Game Control—EBL in LodgeNet PPV Mode only.
OPTICAL DIGITAL AUDIO OUT
Use for amps and home theater systems.
Note: In Standby Mode, this port is not
enabled.
AUDIO/VIDEO IN 1
Connection for composite
audio/video output from
external device.
SPEAKER OUT (8Ω) *
Connect to 8 ohm self-powered
speaker input. Intended for
special applications, such as a
powered bathroom speaker
with volume control.
RS-232C IN
Use for downloading
software updates, etc.
COMPONENT IN
Connection for component
output from external device.
AUDIO IN (RGB/DVI)
Audio connection for
RGB or DVI device.
RJP INTERFACE
Connection for Remote Jack
Pack (RJP) Control cable.
HDMI/DVI IN
Connection for
HDMI/DVI output
from external device.
* This stereo jack provides a mono speaker fixed-level,
1 watt output (audio +, audio -, w/ground shield). Do NOT
plug in a mono connector, as this may damage the TV.
LAN 1
Use for video IP and/or
network connections.
SERVICE ONLY
Restricted to software updates.
To Next Page
Loading...
