ENGLISH
67
39. [Energy Saving] Settings (Command: f j)
Sets the Display Power Management feature.
Transmission
(f)(j)( )([Set ID])( )(Data)(Cr)
Data 00: [Off]
04: 1 minute
05: 3 minutes
06: 5 minutes
07: 10 minutes
Acknowledgment
(j)( )([Set ID])( )(OK/NG)(Data)(x)
* This feature may not be supported on some models.
40. Remote Control/Local Key Lock (Command: k m)
Adjusts the remote control/local key (front) lock.
Transmission
(k)(m)( )([Set ID])( )(Data)(Cr)
Data 00: [Off] (Lock Off)
01: [On] (Lock On)
* When the monitor is turned off, the power key works even in
On (01) mode.
Acknowledgment
(m)( )([Set ID])( )(OK/NG)(Data)(x)
* This feature may not be supported on some models.
41. [Power On Delay] (Command: f h)
Sets the schedule delay for when the power turns on (unit:
seconds).
Transmission
(f)(h)( )([Set ID])( )(Data)(Cr)
Data 00 to FA: min. 0 to max. 250 (seconds)
Acknowledgment
(h)( )([Set ID])( )(OK/NG)(Data)(x)
* The maximum value may differ depending on the model.
42. [Fail Over] Select (Command: m i)
Sets an input mode for fail over.
Transmission
(m)(i)( )([Set ID])( )(Data)(Cr)
Data 00: [Off]
01: [Auto]
02: [Custom]
Acknowledgment
(i)( )([Set ID])( )(OK/NG)(Data)(x)
43. [Fail Over] Input Select (Command: m j)
Selects an input source for fail over.
* This feature is only available when Fail Over is set to Custom.
Transmission
(m)(j)( )([Set ID])( )(Data1)( )(Data2)( )(Data3)( )
(Data4) … ( )(DataN)(Cr)
Data1 to N (input priority 1 to N)
60: RGB
70: DVI-D
90: HDMI1
91: HDMI2
92: OPS/HDMI3/DVI-D
95: OPS/DVI-D
96: HDMI3/DVI-D
97: HDMI3/HDMI2/DVI-D
98: OPS
C0: DISPLAYPORT
Acknowledgment
(j)( )(SetID)( )(OK/NG)(Data1)(Data2)(Data3)(Data4)
… (DataN)(x)
* Some input signals may not be available with certain models.
* The data number (N) may vary depending on the model. (The
data number depends on the number of supported input
signals.)
* This feature operates as the last input, and supports data in
DTV format.
To Next Page
Loading...
Need help?
General
