SPECIAL FUNCTIONS
42
SPECIAL FUNCTIONS
PIP / POP / Twin Picture
SELECTING AN INPUT SIGNAL SOURCE FOR THE PIP
Press the
PPIIPP IINNPPUUTT
button to select the input source for the sub picture.
■
In some models, when the sub picture quality get poor for sub picture, select Auto, PAL, SECAM or NTSC
in PIP System menu.
■
Each press of
PPIIPP IINNPPUUTT
button is pressed, each input source for the sub picture is displayed as
shown below.
SUB PICTURE SIZE ADJUSTMENT (PIP MODE ONLY)
Press the
SSIIZZEE
button and then
FF
/
GG
button to adjust the sub picture size.
■
With
SSIIZZEE
button in DW1, DW2 modes, main and sub picture is adjusted
simultaneously. With
SSIIZZEE
button in PIP mode, sub picture is adjusted.
MOVING THE PIP (PIP MODE ONLY)
Press the
PPOOSSIITTIIOONN
button.
■
Repeatedly press the
DD
/
EE
or
FF
/
GG
button until desired position is
achieved. The sub picture moves up/down or left/right.
TV
AV1 AV2 S-Video2
ComponentRGBHDMI/DVI
AV3
AV4
1
1
1
RGB
AV1
10:30
Win. size
FF GG
Win. position
DD
FF GG
EE
11
PROGRAMME SELECTION FOR SUB PICTURE
Press the
PPIIPP PPRR ++ //--
button to select a programme for the sub picture.
ADJUSTING THE SCREEN FOR THE PIP
In TV or AV modes for the main picture and RGB[PC] for the sub picture,
you can use Auto config and Manual config to adjust the screen of the sub
picture.
■
In TV or AV modes for main picture and HDMI[DTV] or Component
480p, 576p, 720p, 1080i for the sub picture, you can use Manual config
to adjust the screen of the sub picture.
1
1
To Next Page
Loading...
Need help?
General
