29
206-4118
094 - SAP MENU EN (2nd Audio Program)
Set to 1 to enable SAP feature on Function menu, if Function
menu is available. Set to 0 to disable SAP feature on Function
menu, if Function menu is available.
096 - DEF. ASP. RATIO (Default Aspect Ratio)
Selects default aspect ratio at power up.
• Set to 0 for Set By System.
• Set to 1 for 4:3.
• Set to 2 for 16:9 (Factory Default).
• Set to 3 for Just Scan.
• Set to 4 for Zoom.
099 - BACK LIGHTING
Sets the TV screen brightness at power up. Default setting is
200.
• 1 - 100 Static Backlighting.
(1 = Dimmest picture, 100 = Brightest picture.)
• 101 - 200 Dynamic Backlighting.
(101 = Dimmest picture, 200 = Brightest picture.)
If settings are above 101, the TV automatically controls backlight-
ing depending upon the picture level of the current program.
Set
to 255 to disable power savings mode.
102 - ATSC BAND
Sets up TV to receive different types of incoming signals:
0=Broadcast, 1=CATV, 2=HRC, 3=IRC, 4=Same as NTSC.
103 - ATSC TUNE MODE
Sets ATSC tuning mode. Default set to 1 for Physical Channel
scan. Set to 0 for Virtual Channel scan.
104 - START MINOR CHANNEL
Sets XXX-XXX Minor Start Channel number at power up.
0=NTSC. If not 0, number selected is the Minor Start Channel
number.
106 - ASP RATIO LOCK (Aspect Ratio Lock)
Set to 1 to retain previous aspect ratio with power off.
Set to 0 to retain default aspect ratio with power off. See item
096 DEF. ASP. RATIO above.
116 - VIDEO MUTE EN (Video Mute Enable)
Set to 0 for Normal. Set to 1 for Blank.
117 - FACT DEFAULT (Factory Default)
Set to 0 for Normal. Set to 1 to load presets of all item settings.
WARNING: If set to 1, this will reload the factory defaults
and clear the Channel List, including any assigned
channel icons and custom channel labels.
118 - Power Savings
Default is set to 3. When the TV is in Standby mode, the MPI
card slot is powered by the Standby power supply and
embedded b-LAN is not powered. When the TV is in Power
On mode, the MPI card slot is powered by the main 12V
power supply and embedded b-LAN is powered. Note that
the TV must be turned ON in order to communicate with the
embedded b-LAN module for configuration and control when
Power Savings is set to 3.
• 1 = MPI card slot Standby Mode power provided from
Standby power supply, and embedded b-LAN is always
powered.
• 3 = MPI card slot Standby Mode power provided from
Standby power supply, and embedded b-LAN is only pow-
ered when the TV is turned ON.
• 7 = MPI card slot Standby Mode power provided from
Standby power supply, and embedded b-LAN is never
powered.
Installer Menu (Cont.)
To Next Page
Loading...
