10
Connecting to an Antenna or Cable
Connect an antenna, cable, or cable box to watch TV.
The RF cable may not be supplied, depending upon
the model.
CAUTION
Make sure not to bend the copper wire of the RF
cable.
Copper wire
Complete all connections between devices,
and then connect the power cord to the power
outlet to prevent damage to your TV.
NOTE
To improve the picture quality in a poor signal
area, please purchase a signal amplifier and
install properly.
Use a signal splitter to use 2 TVs or more.
If the antenna is not installed properly, contact
your dealer for assistance.
DTV Audio Supported Codec: MPEG, Dolby
digital, AAC, HE-AAC
Other connections
Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable. Depending
upon the model, a cable may not be provided.
Remote Control
(Depending upon model)
The descriptions in this manual are based on the
buttons on the remote control. Please read this
manual carefully and use the TV correctly. To install
batteries, open the battery cover, replace batteries
(1.5 V AAA) matching the
and ends to the label
inside the compartment, and close the battery cover.
Failure to match the correct polarities of the battery
may cause the battery to burst or leak, resulting in
fire, personal injury, or ambient pollution. To remove
the batteries, perform the installation actions in
reverse. This remote uses infrared light. When in
use, it should be pointed in the direction of the TV’s
remote sensor.
CAUTION
Do not mix old and new batteries,
as this may damage the remote control.
When attaching a wall mounting bracket to the
TV, insert the wall mount inner spacers into the
TV wall mount holes to adjust the vertical angle
of the TV. (Use only when provided with your
particular model.)
Provided Item
Wall Mount Spacer
Connections (Notifications)
You can connect various external devices to the TV.
Supported external devices are: HD receivers, DVD
players, VCRs, audio systems, USB storage devices,
PC, gaming devices, and other external devices. For
more information on external device’s connection,
refer to the manual provided with each device.
NOTE
If you record a TV program on a DVD recorder or
VCR, make sure to connect the TV signal input
cable to the TV through a DVD recorder or VCR.
For more information of recording, refer to the
manual provided with the connected device.
The external device connections may differ from
the model.
Connect external devices to the TV regardless of
the order of the TV port.
If you connect a gaming device to the TV, use
the cable supplied with the gaming device.
Refer to the external equipment’s manual for
operating instructions.
In PC mode, there may be noise associated
with the resolution, vertical pattern, contrast
or brightness. If noise is present, change the PC
output to another resolution, change the refresh
rate to another rate or adjust the brightness and
contrast on the PICTURE menu until the picture
is clear.
Depending upon the graphics card, some
resolution settings may not allow the image to
be positioned on the screen properly.
To Next Page
Loading...
Need help?
General
