BASIC OPERATION
34
BASIC OPERATION
INITIALIZING SETUP
If the OSD (On Screen Display) is displayed on the screen
as figure 1 after turning on the set, you can adjust the Auto
Programme tuning, Time Zone selection or Password set-
ting.
1
Welcome
The Following process guides you to
complete initial settings. This initial
setup appears the first time you
turn the TV on. The settings can be
changed in menu once entered.
Installation Guide
Next
Figure 1.
GG
It will automatically disappear after approx. 40 seconds
unless a button is pressed.
GG
This OSD (On Screen Display) is displayed only once
when you purchase TV and turn it on.
NOTE
GG
If you intend to be away on vacation, disconnect the
power plug from the wall power outlet.
Ensure the power cord is connected correctly.
When connected to power the TV switches to standby mode.
■
In standby mode, press the ,
IINNPPUUTT
,
PPRR ++
/
--
button
on the TV or press the
PPOOWWEERR
,
IINNPPUUTT
,
DD//AA IINNPPUUTT
,
LLIIVVEE TTVV
,
PPRR ++
/
--
,
NNuummbbeerr ((00
~
99))
button on the remote control.
Select the viewing source by using the
IINNPPUUTT
button on
the remote control.
■
This TV is programmed to remember which mode it was
last set to, even if you turn the TV off.
When finished using the TV, press the
PPOOWWEERR
button on
the remote control. The TV reverts to standby mode.
To Next Page
Loading...
