ENGLISH
Troubleshooting Network Problems
Depending upon the version of the software, icon position can be changed.
1 Press the (Home) button to access the
Smarthome menu. Select (Settings) and press
OK.
2 Select the Network Network Status menu.
Picture
Sound
Channels
Network
General
Safety
Accessibility
NETWORK
TV Name
[LG] SMART TV LH57*
Network Connection
Network Status
Wi-Fi Direct
Follow the instructions below that match to your
network status.Follow the instructions below that
match to your network status.
Check the TV or the AP (Router).
When X appears next to TV:
1 Check the connection status of the TV,
AP (Router) and cable modem.
2 Power off and power on in the following order;
(1st) the cable modem, wait for the cable modem
to reset, (2nd) the AP (Router), wait for the AP
(Router) to reset and (3rd) the TV.
3 If you are using a static IP, enter the IP directly.
4 Contact Internet service provider or AP (Router)
manufacturer.
Check the AP (Router) or
consult your Internet service provider.
When X appears next to Gateway:
1 Unplug the power cord of the AP (Router) or
cable modem, wait 5 seconds. Reapply power.
2 Initialize (Reset) the AP (Router) or cable modem.
3 Contact Internet service provider or AP (Router)
manufacturer.
When X appears next to DNS:
1 Unplug the power cord of the AP (Router) or
cable modem, wait 5 seconds. Reapply power.
2 After the cable modem or AP (Router) has
initialized (Reset), try to reconnect.
3 Check that the MAC address of the TV/AP
(Router) is registered with your Internet service
provider. (The MAC address displayed on the
right pane of the network status window
should be registered with your Internet service
provider.)
4 Check the AP (Router) manufacturer’s website
to make sure your router has the latest firmware
version installed.
SmartShare PC
SW Installation & Setting
Install the SmartShare PC SW program on your PC.
1 Go to www.lg.com. Then, select your region.
2 Select SUPPORT.
3 Select Software & Firmware. Then, search for your
model. Then, select SmartShare PC SW.
4 Download the SmartShare PC SW and install
it on your PC. You can run the program when
installation is complete.
• SmartShare service is only available if TV and other
devices are connected to the same AP (Router).
NOTE
To Next Page
Loading...
